Remote Came TOP-432 EE / 433.92mhz
search
  • Remote Came TOP-432 EE / 433.92mhz

Remote Came TOP-432 EE / 433.92mhz

CAME021
2010019424245

PROGRAMMING THE NICE FLOR REMOTE

You must remotely enter the radio in the gateway into the programming mode, because the radio remembers authorized remotes, not the remote remembers the gate.

PROCEDURE COPY REMOTE

• Stand at the gate 2-3 meters from the drive.

• 1. On the new remote control you press any button for 5-6 seconds and then release it (the same radio in the gateway enters the programming mode).

• 2. In OLD (ie already operating remote) you press 3 times every second any button (thanks to this the radio knows that you already have a remote control so no outsider will be able to add a remote control to your gateway. At this point the gate should not react. If the gateway starts it will mean that point 1 was not executed properly. Stop the procedure, wait 15 seconds and try again.

• 3. Finally, confirm the fact that you are programming the remote control by pressing any button for 1 second.

Now the new remote should already be working. Copying the remote control is 1: 1, which means no matter which button you use for copying, the remote will have the same programmed gate on the same buttons as the old one. If you have several gates you may find that the remote will not remember all the gates simultaneously. Repeat this procedure when the remote control is not automatically programmed.

INSTRUCTION PROGRAMMING REMOTE NIC 

1. Briefly press the button on the receiver (the LED on the receiver will blink).

2. At the same time, press and hold the button on the remote control that you want to program (the LED on the remote control must be on during programming).

3. After a few seconds, the LED in the ZAMIGA control panel will be 3 times quickly - at this point release the remote control button.

4. After about 10 seconds, the control unit will exit the programming mode (the LED will stop flashing).

The remote will be programmed.

PROGRAMMING REMOTE FLO WITH FIXED CODE.

To program a new remote control, open the remote control by pushing the casing component into which you can attach the keys. The remote control will split into two parts (the housing is not twisted with any screws or other latches). When you open the remote control, set the DIP-SWITCH switches just as they would on a remote control that already works with the gate. The remote has been programmed to your gate!

Data sheet

Number of Buttons
2