Nice Era 003
search
  • Nice Era 003

Nice Era 003

NICE003CZ
2010000073278

Era Series remotes 100% compatible with FLOR remotes (with FLOR encoding). The system is 100% FLOR compatible (also for INTI remotes).

PROGRAMMING THE NICE ERA REMOTE

You must remotely enter the radio in the gateway into the programming mode, because the radio remembers authorized remotes, not the remote remembers the gate. The example shows the addition of an ERA remot to a system where classic FLORs are used. However, an ERA remot can be any new FLOR codec. Each of these remotes can be a "new" remot.

PROCEDURE COPY REMOTE

• Stand at the gate 2-3 meters from the drive.

• 1. On the new remote control you press any button for 5-6 seconds and then release it (the same radio in the gateway enters the programming mode).

• 2. In OLD (ie already operating remotes) you press 3 times every second any button (thanks to this the radio knows that you already have a remote control so no outsider will be able to add a remote control to your gateway. At this point the gate should not react. If the gateway starts it will mean that point 1 was not executed properly. Stop the procedure, wait 15 seconds and try again.

• 3. Finally, confirm the fact that you are programming the remote control by pressing any button for 1 second.

Now the new remotes should already be working. Copying the remote control is 1: 1, which means no matter which button you use for copying, the remote will have the same programmed gate on the same buttons as the old one. If you have several gates you may find that the remotes will not remember all the gates simultaneously. Repeat this procedure when the remote control is not automatically programmed.

INSTRUCTION PROGRAMMING REMOTE NICE 

1. Briefly press the button on the receiver (the LED on the receiver will blink).

2. At the same time, press and hold the button on the remote control that you want to program (the LED on the remote control must be on during programming).

3. After a few seconds, the LED in the ZAMIGA control panel will be 3 times quickly - at this point release the remote control button.

4. After about 10 seconds, the control unit will exit the programming mode (the LED will stop flashing).

The remot will be programmed.

Data sheet

Number of Buttons
2